Suggest an Improvement

Be able to add multiple suppliers on material quotes at once instead of having to do one at a time.

When dragging over a symbol for a count object such as a 2' x 4' light fixture in a ceiling grid, it would be nice if it would only count ones that are inside of the takeoff area the object was in. Ex: If I drag my 2' x 4' light condition over a light that is inside of the area of my ACT-1 area condition, I only want it to count objects that fall inside areas that are highlighted by ACT-1. Right now you have to go back and delete a lot because it picks up lights and other objects inside gyp ceilings and other areas that are potentially out of scope.

When exporting an image file to print to PDF, the only option is to Save as a PRN file and not a PDF file.

When adding legend to a drawing, it doesn’t scale properly when zooming in and out

I consistently use LF, Area 1 Side, and Segment Count, when taking off exterior walls. In the old OST the 'Worksheet' tab showed all 3 Qty's for that condition. In the Assemblies tab here I can only see the primary Qty, LF for instance. There needs to at least be an option to see all takeoff Qty's selected within an assembly.

From the vendor's email.. "My only complaint about Buzz Bid is that is doesn't say who and the company is in subject line or the sender's name. It only says form "BuzzBid" and then the job name. Minor thing for sure but only thing I've seen that is inconvenient on our side. Now once you open it up obviously all the information is there. It comes back to us already in a PDF which I really like.

when pricing 2x4 ACT; 2ft round up is too little and 4ft is too much compared to our past pricing models. Create another option for round up that links to your 2x4 or custom grid size would be an intuitive solution to the problem. I am assuming that it would be just the average between the two dimensions, but not 100% sure.

I have a project that is a 3 story building, with left and right sides to it, with only the right side depicted as the left side is a duplicate and flip of the right side. Using Locations already for the white box stuff, and Multi-Count feature for the differing units. I would like to have an option for a count on the number of buildings, rather than creating Building 1-4 in the Location, and then assigning / or re-assigning the locations to each of the 4 buildings, or have to duplicate the takeoff on one building (duplicating pages of takeoff). Or another perhaps simpler way to handle this task without creating additional pages with takeoff (all repetitive of Building 1), would be if there could be a page repeat option in the SETUP tab (allowing for any takeoff on one page to be duplicated by a multiplier of page repeats.

On bid proposals, it would be helpful to have the option to select the submitting office location. For example, SDI's BuzzBid account is set up through our accounting office at 3100 Palisades Dr, Corona, CA, which automatically populates on the Bid Proposal letter. However, if SDI's Las Vegas, NV office submits a bid, the proposal still reflects the Corona, CA contact information. Adding an option to select the "Bidding Office" would ensure that the correct office address appears on the proposal.

Can we please get a "move up/move down" button for the assembly #'s in the takeoff list?